Silverfish Longboarding - The Longboard Skateboarding Community - View Single Post

boogaloo28 · 05-22-2008, 02:05 PM

I use a laminate trimmer made by rigid. Its basically a handheld router with a 1/4" shank rather than the beefier 1/2" shank. Slap a roundover bit in there and you're good to go. Just make sure your edges are nice and smooth before you run the trimmer over it; i recommend a hand plane to get any bumps out.
If you don't wanna invest in powertools, a decent sized sureform is way quicker and easier to use than sandpaper.

05-22-2008, 02:05 PM	#3 (permalink)
boogaloo28 Addicted Cruiser Join Date: Dec 2002 Location: Portland, OR Age: 23 Posts: 952	Re: those freakin' sides on the board I use a laminate trimmer made by rigid. Its basically a handheld router with a 1/4" shank rather than the beefier 1/2" shank. Slap a roundover bit in there and you're good to go. Just make sure your edges are nice and smooth before you run the trimmer over it; i recommend a hand plane to get any bumps out. If you don't wanna invest in powertools, a decent sized sureform is way quicker and easier to use than sandpaper.

Sponsored Links