- Redrilling oldschool plates?
- indys or bones bushings?
- Chris Chaput style board with randals
- Trucks for the minicarve
- WHich trucks for a large...6ft long board?
- Randal Baseplates... Again
- Exkates
- flipped r2 hanger
- Trucks for an Urban Assault
- DH trucks
- jones trucks?
- Is this a good deal for G&S trucks
- sixtrack debate
- Turning vs. wobs
- ACS 430
- My Exkates broke and Jims sending a new hub
- khiro bushings
- S9 Pivot Replacements
- Truck Design
- i need some help! i want to cut down my trucks
- Aggro's with Stim's arrived
- Stims are HUGE
- Info needed on Fury trucks.
- Look Familiar....The Phoenix from Gullwing
- Need some help
- 8mm axles
- Lookie what I got!
- Originals for slalom?
- luge trucks
- MMW
- Siesmic Combos
- Randall RII on Insect Dragonfly
- Green Stims???
- swapping bushings over on Randal trucks
- Landing Lytz
- nuclear pickles
- Plan on gettin Exkates, is this the right choice?
- Randall dh baseplates and 180 hangers
- Pivots
- What trucks on a 7' board?
- Top Stimulator?
- Rubber truck bushings, better than stims?
- Ate shisil with my exkates
- Randal Baseplates...
- anyone else have Carver Trucks?
- Truck Heights
- DH bushings???
- Bushing Questions
- original's bushings
- DH and R2
- best trucks for pumping?
- Truck Sizes
- my trucks dont seem to whant to tightin
- Inverted Kingpin Trucks
- uptrucks vs. original
- Bought more Indy's
- flowboard trucks? where can i get them?
- which seismic to get for my size
- Trackers too turnny !
- Herbn's Trucks..
- whats the diff btween all kingpin and what does it matter?
- questions about trucks and sharp turns
- Jim Z speed hanger trucks.
- gullwing trucks anygood
- nuclear pickle
- Randals at Mile High
- Distributors with Originals??
- Highway Fox Trucks
- noob needs help with this deck
- Stims are #1, what's #2?
- Sick Bushing combo
- Truck washers
- drill size for baseplates
- Randal DH
- Randals vs. Originals
- So I bought my randalls.. now what
- 8mm axles
- 120mm - 130mm cut down RII hangers
- MAGUN Donwhill Trucks!!
- UPTRUCKS FOR DOWNHILL?
- Best Randal 150 setup?
- Xeno Plates!!!!!
- Recommend Trucks?
- Stroker Trucks!!!!
- Seismic Axle Threading
- V-shocker?
- need help on a different truck setup
- Crail Speed Trucks!!!
- Newbee Question please help out
- Randal VS. Seismic Carving
- Randal Trucks
- Front bushings, back bushings, top bushings, bottom bushings
- difference between seismecs and randlas
- BIG trucks
- Upgraded Kingpin not sitting Flush??
- randal trunks need risers?
- best bushing setups?
- Randal Truck mods
- Archealogical dig proves sucessful.
- Torsion
- green stims
- trucks for the landy dh? rII's vs s8's
- Randalls
- indys?
- Indy stage 9's a no go
- I need axle stock!
- Stims!!
- seismic spring setups...
- Randal front Tracker back
- New Radikal Downhill Trucks...
- soft angled risers vs hard?
- Exates vs Baku's
- Tracker Stimulators vs new superballs?
- grade 8 busted
- Why change randal kingpin, bushings?
- Randal 2's vs Indys - height?
- Carver Trucks in Europe?
- Tracker 129's - which way?
- What size trucks?
- Drop-Thru Trucks
- breaking-in bushings?
- Radikal Titanium Offset Truck!!!
- Truck Dimensions
- A question on trucks
- RII 150 width
- truck width for siesmics
- Seismics, randals, originals, torsion
- crail trucks
- Loose Wheels On Originals
- Gullwing ripoff Randal
- New complete
- I got MY randals
- Why change kingpin?
- Kingpin replacement?
- flipping hangers
- pickles?
- 180 hanger on the DH baseplate?
- randal bushings
- Invaders for .99 hahaha
- Good trucks for the park??
- Bushings
- I got seismics on my cosmic2
- Stimulator bushing
- Carving like the teacups in disneyland!!! Which trucks?
- randal rII 150
- Where to get a good deal on RIIs
- UP Trucks or Randal's?
- Flipped Hangars?
- Small Axle
- Randal baseplates
- Which Randal Trucks for bombing???
- Offset trucks
- Preffered braking trucks
- Randall 150 upgrade
- Question about truck sizes?
- Seismics on UA review
- stability 25-40, ok sliding
- 8mm axles?
- Randal Setup
- tracker stimulators on randal dh trucks?
- seismics on my koi
- new zeeland riders?
- Indy bushings
- seismics on a dh
- Randals or Seismics?
- Sector 9 board. HELP!
- Indy Problems
- new trucks
- Randall DH's VS Randall II's
- Seismics or Randals for Speed?
- Best wider Slalom Truck?
- Favorite Trucks
- powder coating trucks???
- [ Help ] What trucks?
- Speed Trucks
- I know what type of bushings i want, anyone help with duro?
- I got my Siesmics
- New Randals, destroyed bushing
- Exkate Torsion Trucks
- randel strutts
- From Randals To Seismics...
- stripped axle? nut?
- holy crap this is annoying.
- flipping 150's?
- Randal base plates,
- Randal baseplates?
- Damaged axle threads
- Randal black bushing´s...red..or yellow? Blue maybe?
- Gullwing 259 (the superwide things)
- Bushing setup question.
- Trackers
- 2 questions
- r2's too big for a 38 cosmic??
- Super Carving! from Radius: 8ft to 2 ft for any trucks
- Bushings for Randal 180s
- Where can I find comp 2 hangers?
- What bushings should i use on my 180's
- Brakeboard or SkateBrake
- soulboard 48 inch trucks?
- How do you prevent speed wobbles?
- Uh.. axles & stuff.. click to read please!!
- the time to choose has come
- originals on cosmic 2
- Seismic's any good?
- Opinions on 184 dart Trackers?
- New Truck...
- Choosing mounting screws
- randal dh's on my r-iv
- what you know about RISERS
- tracker race truck rtx 8 mm axle upgrade
- gullwings
- Cutouts for Seismics
- indies VS ventures
- sorry, double post
- Carving trucks...
- Seismics on a UA
- trucks for a pool board?
- Randal Upgraded Kingpin
- Indies vs Trackers
- question about original carving trucks
- Gullwing 15 inchers
- hangar thread size
- a bushing thread
- Originals and Seismics
- Carver trucks
- wich trucks?
- So what size are Randal 150's really?!
- mountain board trucks on a longboard?
- QUESTION ON RANDALS
- Unit trucks?
- randal dh's....
- mni board trucks
- skyhook trucks
- skate spots
- Blue Hardcore bushings...
- indys vs randals
- mixed signals on these randalls
- What Trucks
- odd...
- khiro bushings?
- Liquid trucks?
- I HATE RANDALS!!!
- Decreasing truck angle?
- Irritating bushings and what to do.
- Bushing Question?
- How do you measure trucks?
- Question about my loaded vanguard?
- pivot
- carver trucks
- Sliding/Bank trucks and Fav. Trucks poll