new evo grip coming loose

**loug** · 11-21-2009 11:16 AM

board is about a month old and grip is coming off. put pin holes in bubbles, push it down and it pops up by the next day. any solutions?

**TKC** · 11-21-2009 11:21 AM

If there's nothing wrong with it besides a couple of bubbles you can always get over it and go skate.

And then there's the magic of re-gripping with your own flava.

Either way's good.

**MatiasMinHo** · 11-21-2009 11:21 AM

Put on some new griptape!?

**AfterHoursBoarding** · 11-21-2009 11:48 AM

Originally Posted by MatiasMinHo

Put on some new griptape!?

Hell yeah man, add your own touch to it and its not expensive for a sheet of griptape.
I plan on re-taping mine soon.

**grey HAM** · 11-21-2009 01:53 PM

Originally Posted by AfterHoursBoarding

Hell yeah man, add your own touch to it and its not expensive for a sheet of griptape.
I plan on re-taping mine soon.

get Vicious?

**boarderaholic** · 11-21-2009 02:41 PM

Originally Posted by loug

board is about a month old and grip is coming off. put pin holes in bubbles, push it down and it pops up by the next day. any solutions?

I'm going to go out on a limb and say that if the grip tape is coming off...then the obvious solution would be to buy some new grip and regrip the board?...?

**AfterHoursBoarding** · 11-21-2009 03:02 PM

Originally Posted by grey HAM

get Vicious?

Haha no intention, it just kinda reminded me that I need to get mine done soon.

**loug** · 11-21-2009 09:59 PM

Originally Posted by TKC

If there's nothing wrong with it besides a couple of bubbles you can always get over it and go skate.

And then there's the magic of re-gripping with your own flava.

Either way's good.

not a couple of bubbles more like one about 2" x 5" and the edge is lifting up too. there was the same happening at the front but a couple of pin pricks and it was pressed out. sucks on a new board aint even beginning to wear. have new grip just hated to waste what was already on the board.