I'm putting randalls on a flex 2 dervish. And Lemon BigZigs. I want a smooth ride, carvy, u no. Should I leave to stock bushings on there? Anyone have any ideas for bushings?
Seconded. Just take them out and put the kingpin in all by itself.
You should be good to go.
The bushing-less trucks are carvy, but I prefer the marginal improvement in stability with my Khiro double barreled with medium-soft on bottom and soft on top.
__________________
You turn any tricks on that wheelie board?
weigh 155 ( :
I don't want to take the bushings out completely. Not stable enough. I guess I should have said this in the original post but; I'll be using this board for alot of commuting and pumping as well as carving.
weigh 155 ( :
I don't want to take the bushings out completely. Not stable enough. I guess I should have said this in the original post but; I'll be using this board for alot of commuting and pumping as well as carving.
mine has paris trucks with stock randal bushings, but looooooose and with no washer on the bottom barrel bushing. they might not last as long (although they are totally fine after 3 weeks), but the ride (with a flex 2 and lemon big zigs) is amazing. so turny. so smooth. it's buttah babeeee. you could probably have almost the exact same feel with your randals, just loosen 'em off a bit.
you could also try putting in some venoms stims.
__________________
Quote:
Originally Posted by D_Rezz
I was thinking of cutting the grip tape to look like a busty viking queen holding onto the leashes of a pack of rabid huskies.
Get some flat washers and leave the stock bushings in there. You will be fine. Home Depot has the flat washers for .09 each. Stock code "ABB" is stamped on the washer.
The bushing-less trucks are carvy, but I prefer the marginal improvement in stability with my Khiro double barreled with medium-soft on bottom and soft on top.
Bushings on a dervish?
