Question on Kingpin Lengths

[zacks.on.fire]

How are kingpin lengths measured? It is from the top of the bolt head to the end of the bolt or does the measurement start from underneath the bolt head?
___
|......|___________________
|.......................................|
|......___________________|
|___|
^
or
___
|......|___________________
|.......................................|
|......___________________|
|___|
^
(sorry for the ASII drawings...don't have a camera/image editor available right now)

[Cann0n]

Under the head.

[GriffinSk8]

Under the head.

I agree under the head.

[loug]

under the head

[Mile_High_Mark]

Conventional hex-head bolts (kingpins) -- under the head
Countersunk-type bolts (mounting hardware) -- including the head

[urbs]

haha its a cawk

[Barf]

haha its a cawk

In that case, you measure from the top of the head.. you wanna claim all the length you can.

[Cann0n]

In that case, you measure from the top of the head.. you wanna claim all the length you can.

Shaving makes it look bigger too... I got a how-to floating around here... Just search posts by me that contain "razor" or "itchy"

[zacks.on.fire]

I just knew this thread would go downhill...but thanks for the responses anyway

[Shavarsh]

I bought a 2" kp and some elims and supercarves for some mission ones,has anyone measured the stock kingpin? will the elim in the bottom and the cone on top work?
I have been running elim bottoms, but the cone is big in the supercarves

[stringtheory]

I would think you'd need at least a 2 1/4" to fit an Elim and a tall cone.

[Mile_High_Mark]

Most street-type trucks (Indy, etc) use 2" kingpins. If you want taller top bushings, go 2.25".