MY ORIGINALS HAVE NO REBOUND!

[droplet]

I bought S10's yesterday, put them on my deck today and nothing.... They go down but don't come back up. I loosened um just about all the way and still nothing. Any ideas?

[Mr. Zogs]

are they like, flopping with no rebound, or just tight and when get pushed down get stuck

[droplet]

they are tight...when you push them down they stay there

[EBasil]

they are tight...when you push them down they stay there

Something is very wrong. They should *snap* back to center when you step off the board. Man, you just gottem and screwed them up, already?! CALL Original. Scott's usually in there and I bet you can figure things out over the phone. Of course, he also posts here, but time is on your side if you "reach out and touch someone".

[laserblast]

uhh, my s8's have rebound like a ****trampoline...
but I also have those K2 trucks, which have absolutely no rebound.



what I'm saying is: I dont know, nevermind...
( lost my point)

\/ urm like, BEST POST EVER!!

sorry

[Sensei]

Step off the board, push it down with your foot and just lift up your foot (without standing on it). If it doesn't snap back up you got problems.

Check to see if the bushings broken or cracked. Check to make sure the spring is in the right way. You may want to disasemble and reasemble, follow the instructions they got on thier site for cleaning and lubing the trucks.

Call Scott if you still got problems. He's a real nice guy and will help you and probably replace anything if there busted.

[Mr. Zogs]

also, if u loosen them too much, soemtimes they can lose contact with the spring i think, which would give them rebound, but the hangar would be all floppy, not tight

[RustyBurrito55]

My S10s have MASSIVE rebound. Tighten them up not loosen them. When mine are loose they have almost zero rebound.

[Start_a_Revolution]

most of the time when that happens, it just means that you broke a bushing... either order a spare set off the website, or give scott a call at the Original office

[Bushman]

yup my S10s are reboundy like a

[Original]

The above poster is right,
Something is deffinately pretty screwed up.

Being that you are getting no rebound I am not sure what the problem could be.

We should be able to figure it out with some more details though,
Give a call 800-619-5579

[urubullino]

the place where the bushing turn can be narrow excessively you will have that to widen the circumference where it is.
Can be it.
Disassemble the truck and verify if bushing turn free into the truck.