Rasta Chargers

**yetti123** · 10-09-2008 07:10 PM

i dont know if anyone else has posted this, i couldnt find anything on the search but
how do the new rasta chargers compare to the other chargers, not the old really good ones but the ones that have problems

**lsdmt** · 10-09-2008 07:53 PM

Everyone know that rasta colors add at least 15 horsepowers and 36 torques.

**vinvam** · 10-09-2008 08:00 PM

aren't they the same as the "new" chargers?
the only thing different is the paint job...

**yetti123** · 10-10-2008 08:31 AM

Originally Posted by vinvam

aren't they the same as the "new" chargers?
the only thing different is the paint job...

well i figured that but i wasn't sure if they made any changes to it so r they the same

**Camel** · 10-10-2008 08:59 AM

They still need flat washers to keep from chewing the bushings up.

**yetti123** · 10-10-2008 09:52 AM

k and what the duro of the stock bushings

**Mile_High_Mark** · 10-10-2008 10:29 AM

The latest batch of bushings seems to be better than the previous batch.

**yetti123** · 10-10-2008 05:00 PM

ok but what duro r they

**Mile_High_Mark** · 10-10-2008 05:17 PM

Originally Posted by yetti123

ok but what duro r they

I could tell you, but only if you promise to start using your <Shift> key, and the letters "a" and "e."

**yetti123** · 10-10-2008 08:06 PM

Originally Posted by Mile_High_Mark

I could tell you, but only if you promise to start using your <Shift> key, and the letters "a" and "e."

what im confused wait r u telling me or not

**Dinosaur** · 10-10-2008 08:24 PM

Originally Posted by yetti123

what im confused wait r u telling me or not

sigh, he means to start spelling out whole words. so instead of "u" it is "you" or "r" becomes "are"

**yetti123** · 10-10-2008 09:03 PM

Oh ok, then can someone tell me what duro the bushings on the chargers are?
Thank you kind sirs
Sincerely,
Me

**Mile_High_Mark** · 10-10-2008 09:43 PM

I pulled some off the new rasta Chargers, and measured them at 87a. Note that this isn't completely accurate because the durometer's pin is very close to the edge of the bushing (which affects the accuracy of the measurement).