Baseplate idea...

[Shiyuchi]

What if someone made a baseplate, that on the bushing seat, the metal was recessed, so that it was far enough away from the hangar, you could fit two normal sized bushings underneath the hangar. I assume it would add quite a bit of lean and make the trucks much carvier.

Would this work?

[robert borek]

yup im sure it would work! might jus feel floppy though.

try using khiro whites in your trucks.. if theye not loose enough then.. then your crazy:P

[enemy combatant]

Bennetts have super tall bushings and are really turny so I guess that makes sense.

[mcgoon]

If they bread dogs that shot bees out of their mouths would those dogs #### honey? Would you eat it?

[xedell]

Originally Posted by mcgoon

If they bread dogs that shot bees out of their mouths would those dogs #### honey? Would you eat it?

Лол шут?

10flamebroiled rusian pears with mouths

[xedell]

any way i'm pretty sure that karrot has done something similer on some of his custom baseplates at least from pictures I see that some of them can hold very tall bushings.

[SteveC]

there's a limit to how far you can go and still give the baseplate enough strength to hold the kingpin - either that or you end up with a high plate, which now that think about it actually wouldn't be too bad for a dedicated carve truck.

[speshlspeclsteak]

Originally Posted by xedell

any way i'm pretty sure that karrot has done something similer on some of his custom baseplates at least from pictures I see that some of them can hold very tall bushings.

he did... i haz them, not quite 2 bushings but theyre effin huge/tall

[stephen.mhsrider]

he did... i haz them, not quite 2 bushings but theyre effin huge/tall

holy crudd, they are some insane looking trucks...

[SteveC]

Tracker hangers on Karo-go baseplates

[Shiyuchi]

Well, what I was thinking is you just take your normal truck, and around the bushing seat, you just drill a bushing sized hole.