10mm bearing vibrations?

[jizmnky]

ok so i was cleaning my landy 10mm ceramics because they were crackling and going a little bit slow and when i took them out of the alcohol and spun them, some, actually most of them would vibrate to a near stop like there is too much play in them...

has anyone had any experience with this and can help figure out my problem? thanks

[karrot]

youre not supposed to spin them without lube
the alcohol takes away the lube
good job man

lol

[latenite]

put some toothpaste in them, spin em a little, then wash out the toothpaste, then put the lube in them.

[jizmnky]

no no, i did put lube in them and then spun them to work the lube all the way around (that was after i dried them with the compressed air thing)

[omaron91]

well try putting it all back together and then test it.

[CrazeeeJ]

Put them in some wheels ... Any bearing will do that if spun with only fingers i have seen it with 8mm... and My 10mm landys....

just make sure there lubed and put it together,.... the wheel makes a big difference ..

late