screw size, risers, trucks,

[otangsftw]

im getting a landyachtz drop speed for xmas (a dropthrough deck) i dont know alot about drpthroughs or w/e you call them and i was wondering 1. how long do you need the screws to be for my grizzlies, can you put risers on a dropthrough, i wanted to put those sunrisers on for nightriding and hw do you put the trucks on so if any one can help uh ya

[jaytoo]

im getting a landyachtz drop speed for xmas (a dropthrough deck) i dont know alot about drpthroughs or w/e you call them and i was wondering 1. how long do you need the screws to be for my grizzlies, can you put risers on a dropthrough, i wanted to put those sunrisers on for nightriding and hw do you put the trucks on so if any one can help uh ya

I'm assuming the drop speed isn't more than 1/2 inch thick; you'll probably need at least 1.25 in hardware. It doesn't really hurt to go a bit longer, 1.5 in will work for sure.

Normal risers don't do anything functionally on dropthroughs, but you can mount them on top of your trucks if you're wanting to use the lighted ones (though I would wholly encourage making your own). If you ended up doing that, your hardware would need to be longer by however thick the risers are.

This vid will be helpful if you've never assembled a board before:

YouTube - How to set-up a Drop Thru board

[otangsftw]

thanks alot man i think im gonna go maybe 1.5 ot 1.25 idrk thanks 4 the vid 2

[Fortune]

thanks alot man i think im gonna go maybe 1.5 ot 1.25 idrk thanks 4 the vid 2

1.25 is fine for my DSpeed and Grizzlies. Still plenty of room left.