toe stops

**Nasty Nathan** · 01-21-2008 05:36 PM

I think that MHS or some other online stores should make a toestop package that includes a barrel bushing, a 3" screw and nut, and the proper washers I think that would be a great package so that you dont have to order whole sets of 3" screws and stuff

**243racing** · 01-21-2008 05:39 PM

Or... you could just use your own old bushings and a 50 cent screw and bolt from home depot.

**Ian** · 01-21-2008 05:56 PM

Originally Posted by Nasty Nathan

I think that MHS or some other online stores should make a toestop package that includes a barrel bushing, a 3" screw and nut, and the proper washers I think that would be a great package so that you dont have to order whole sets of 3" screws and stuff

You don't need a 3" screw, I used a 1.75" on my voodoo with a bottom moog bushing. Just use bushings you don't need or old ones.

**pavedwave** · 01-21-2008 08:57 PM

It all depends where you're planning to put your toe stop.

A common config I would do is on the front left hole, up through the hangar and riser(s), so it required at least a 2"-1/4" screw.

If you put one up through the back left or right hole, meaning the screw has to go through the thick end of your wedges, plus the truck hangar, plus the deck, then you might as well try a 3" screw, then just snip the top off with bolt cutters after you're all done setting the bushing and washers the way you want them.

On the other hand, if you're putting the toe stop dead center, and drilling another hole in the deck just for it, then a screw 2" or less may be fine.